. . . and it shapes up like this
Page 16

Page 17

If you've noticed an error in this article please click here to report it so we can fix it.
SCANIA provided CM with two of the new 38-tonne combinations last week, writes BILL BROCK.
Both tractive units were sleeper cab R112s, the first being a 4x2 tractive unit coupled to a 12.2m (40ft) York tri-axle Lo Deck platform trailer based on a new wider mainrail chassis for increased stability. It had sideguards.
Loaded to maximum weight, the air-to-air intercooled engine giving a power to weight ratio of 6.45 kW/tonnes (8.78 bhp/ton) and producing 1,395Nm (1,025 lbft) or torque at 1,250rpm had little difficult in pulling away from rest using fourth gear.
Gear selection of the 10-speed synchromesh range change Scania GR 870 box proved to be sticky at first but either I or the box improved as we both warmed up after a cold start. On the flat, sixth ratio could be skipped without much loss in acceleration but it was needed dur ing hill climbing.
Over A-road running at 40mph, maximum torque coincides with the legal speed limit using top gear.
A geared maximum speed of 67mph allowed a 60mph cruising speed at about 1,800rpm and top gear was easily held (3% medium motorway gradients.
The second vehicle was similarly-specified 6X4 with trailing rocking bar rear axle al was coupled to a York two-a) trailer.
Gear selection was mui smoother, and improved sta ility in roll and pitch w, apparent from the outs( appearing to give a better fc through the steering and mo even ride.
Initially this vehicle is avz able with a 3.1m (10ft 21n) whel base but after Type Approval will be offered with a 2.85 wheelbase (9ft 4in) thought suit the overall length requir ments of most operators.
The rear axle on this moc will have a narrower track givir greater turning clearance front of the landing legs of tl trailer.
As it is offered now, slow at tight forward manoeuvres pr sented no tyre-scrub problerr There were no hump bat bridges on the route to test ti ground clearance of the 511 guards but the 550mm (1ft 91/2i gap (set with a level platforr
ks to be adequate.
ks the vehicle articulates durturning, the sideguard preits a leading edge unshielded the rear wheels of the tractive t, and it is worrying to note t a gap opens up in which (thing or anyone entering uld have no chance of es)e.
he tri-axle tractive units can used with suitable existing o-axle trailers for 38-tonne eration.
ihould the trend move to trie trailers in the future ScaI's layout lends itself to an sy conversion to two axles.