CLAIM REJECTIONS
Page 51

If you've noticed an error in this article please click here to report it so we can fix it.
According to Scania's Mick Palmer, the following typical warranty issues would cause the manufacturer to reject a claim: • Fair wear and tear. This often occurs with brake and clutch friction material, some brushes, and fan belts.
• An over repair. Manufacturers insist that the repair method is their decision and stipulate that the most economical (proper) repair is carried out. A customer will sometimes insist on replacement rather than repair, and if a dealer does this without authority a claim can be rejected.
• Vehicle abuse or 'incorrect driving method'. High torque ratings make it easier to damage the vehicle. Examples include: premature clutch wear caused by the vehicle being driven away in too high a gear; differential lock problems caused by being forced in with wheels turning at different speeds or being left in after use; half shafts suffering torque twist.
• Poor servicing and repairs, This is not something Scania suffers from as servicing is included in the two-year R&M scheme. If a failure is due to lack of lubrication, this will be seen on inspection.
You can reduce exposure to potential claim rejection by following this advice: • Ensure service is to the manufacturer's instructions; follow lubrication rules.
• Make sure the driver is familiar with the vehicle and encourage sympathetic driving techniques, • Report a fault to the manufacturer's agent as soon as possible-claims may be only partially accepted, or even rejected, if a fault isn't reported straight away and causes consequential damage.
• If your vehicle is recovered, don't forget to remove the prop shaft it could save a huge bill for a replacement gearbox.